H3C H3CNE GB0-191-ENU

경쟁율이 치열한 IT시대에 GB0-191-ENU시험을 패스하여 자격증을 취득함으로 IT업계 관련 직종에 종사하고자 하시는 분들께는 아주 큰 가산점이 될수 있고 자신만의 위치를 보장할수 있으며 더욱이는 한층 업된 삶을 누릴수 있을수도 있습니다. GB0-191-ENU덤프로 GB0-191-ENU시험에서 실패하면 GB0-191-ENU덤프비용을 보상해드리기에 안심하고 시험준비 하셔도 됩니다.

가장 최근 출제된 GB0-191-ENU인증시험문제를 바탕으로 만들어진 적중율 최고인 GB0-191-ENU덤프로 간단한 시험패스는 더는 꿈이 아닙니다. GB0-191-ENU덤프는 pdf버전과 온라인버전으로 되어있는데 pdf버전은 출력가능하고 온라인버전은 휴대폰에서도 사용가능합니다. GB0-191-ENU덤프를 패키지로 구매하시면 더 저렴한 가격에 구매하실수 있습니다.

GB0-191-ENU인기덤프자료는 고객님의 IT업계 종사자로서의 전환점이 될수 있습니다. GB0-191-ENU시험을 패스하여 자격증을 취득하여 승진 혹은 연봉협상 방면에서 자신만의 위치를 지키고 더욱 멋진 IT인사로 거듭날수 있도록 고고싱할수 있습니다. 인기 높은 GB0-191-ENU덤프자료는 시중에서 가장 최신버전으로서 시험패스를 보장해드립니다.

GB0-191-ENU시험을 빨리 패스해야 되는데 어디서부터 어떻게 시험준비를 시작해야 하는지 갈피를 잡을수 없는 분들은 저희 사이트를 주목해주세요. GB0-191-ENU 최신버전 덤프만 공부하면 시험패스에 자신이 생겨 불안한 상태에서 벗어날수 있습니다. GB0-191-ENU덤프는 시장에서 가장 최신버전이기에 최신 시험문제의 모든 시험범위와 시험유형을 커버하여 GB0-191-ENU시험을 쉽게 패스하여 자격증을 취득하여 찬란한 미래에 더 다가갈수 있도록 도와드립니다.

H3C GB0-191-ENU 시험 요강 주제:

최신 H3CNE GB0-191-ENU 무료샘플문제

1. Xiao L is a senior IP network expert, determined to develop a new dynamic routing protocol. Which of the following should be included in the working process of a routing protocol? (multiple choice) (multiple choice)

A) Found neighbors
B) Maintain and update routing
C) Switch routing
D) Calculate route

2. An MSR router is connected to the Internet through the S1/0 interface, and the GE0/0 interface is connected to the LAN host. The network segment of the LAN host is 10.0.0.0/8, and there is an FTP server with an IP address of 202.102.2.1 on the Internet.
By configuring the IP address and routing on the router, the hosts in the current LAN can access the Internet normally (including the public network FTP server). Now the following configuration is added to the router:
firewall enable
acl number 3000
rule 0 deny tcp source 10.1.1.1 0 source-port eq ftp destination 202.102.2.1 0
Then apply this ACL to the inbound and outbound directions of the GE0/0 interface, then which of the following intentions can this ACL achieve?

A) Only prohibit the FTP data connection from the host whose source address is 10.1.1.1 to the destination host 202.102.2.1 whose port is TCP 20
B) There is no restriction on the FTP connection initiated from 10.1.1.1 to 202.102.2.1
C) The host whose source address is 10.1.1.1 is prohibited from initiating FTP connection to the destination host 202.102.2.1
D) Only prohibit the FTP control connection from the host whose source address is 10.1.1.1 to the destination host's 202.102.2.1 whose port is TCP 21

3. The Serial 0/0 and Serial 0/1 interfaces of the router of the Shenzhen branch of XYZ company are connected to two different ISPs through two WAN lines, and through these two ISPs, you can visit the website of the Beijing head office at 202.102.100.2, in Shenzhen. The following static routes are configured on the router of the branch office:
ip route-static 202.102.100.2 24 Serial 0/0 preference 10
ip route-static 202.102.100.2 24 Serial 0/1 preference 100
So which of the descriptions of these two routes is correct? (multiple choice)

A) The destination address of the two routes is the same, which can be active and standby, and the first route is the master
B) The Cost value of the two routes is the same
C) The priority of the two routes is different, the router will write the first route with the higher priority into the routing table
D) The priority of the two routes is different, the router will write the second route with the higher priority into the routing table

4. The customer's network connection looks like:
HostA----GE0/0--MSR-1--S1/0-----WAN----S1/0--MSR-2--GE0/0----HostB
The customer's WAN network only supports synchronization, and S1/0 of MSR-2 needs to negotiate an IP address from the opposite MSR-1 instead of manually configuring a static IP address.
Then the S1/0 interface of the two routers can run ______. (Multiple choice)

A) PPP+RIP
B) PPP
C) HDLC+RIP
D) HDLC

5. The two empty-configured MSR routers MSR-1 and MSR-2 are directly connected through their respective GE0/0 interfaces, and the IP addresses on GE0/0 of MSR-1 and MSR-2 are 10.1.1.1/24 and 10.1.1.2. /24, there is IP reachability between two GE0/0 interfaces.
Then added the following OSPF configurations on the two routers:
MSR-1:
[MSR-1-ospf-1] area 0.0.0.255
[MSR-1-ospf-1-area-0.0.0.255] network 10.1.1.0 0.0.0.255
MSR-2:
[MSR-2-ospf-1] area 255
[MSR-2-ospf-1-area-0.0.0.255] network 10.1.1.0 0.255.255.255
Then the correct description of the above configuration is _____. (Multiple choice)

A) The OSPF interfaces of the two routers belong to the OSPF area 255
B) The command network 10.1.1.0 0.255.255.255 on MSR-2 cannot start OSPF on the GE0/0 interface of the router
C) The command network 10.1.1.0 0.0.0.255 on MSR-1 means to start OSPF on the GE0/0 interface of the router and join the corresponding area
D) The OSPF interfaces of the two routers do not belong to the same OSPF area, and the OSPF Area of ​​one of the routers is incorrectly configured

질문과 대답: